NEIEP 800 Final Exam Version 2 (Latest 2023/ 2024 Update) Questions and Verified Answers| 100% Correct| Grade A

NEIEP 800 Final Exam Version 2 (Latest

2023/ 2024 Update) Questions and Verified

Answers| 100% Correct| Grade A

Q: With wye-delta, reduced current starting is accomplished without the need for _____.

Answer:

resistors

Q: _____ run buttons should run the platform and sling at leveling speeds only.

Answer:

Temporary

Q: A _____ _____ consists of a piston held closed by an adjustable spring and must open at a

certain pressure to prevent any further increase in pressure.

Answer:

relief valve

Q: A _____ lowering valve allows the car to be lowered at a speed not exceeding 20fpm in case

of power failure.

Answer:

manual

Q: As the oil temperature changes, the _____ will change as well and will effect the

performance, more specifically, the leveling and approach of the elevator.

Answer:

viscosity

Q: Be sure wellways are properly _____ to avoid accidental injury to you, your team or anyone

working outside of our industry.

Answer:

barricaded

Q: Barricades around the wellway must be _____ inches high and be capable of withstanding a

_____lb force.

Answer:

42, 200

Q: A _____ protects you if you come in contact with a hot wire or component and then come in

contact with ground. It opens the circuit and diverts the supplied current to ground.

Answer:

GFCI

Q: A _____ _____ is useful for horizontal (side-to-side) pulling of the truss while being

lowered into the wellway.

Answer:

lever hoist

Q: Code specifies the use of anti-slide devices if the outer edge of the deck is greater than

_____ inches from the center line of the handrail.

Answer:

12

Q: (True/False) Anti-slide devices must be less than 3/4" in height, have no sharp corners or

edges and fastened to the deck no closer than 4 inches from the handrail and spaced no greater

than 6ft apart.

Answer:

True

Q: Sometimes referred to as sag switches, _____ _____ switches are located within the step

band of both upper and lower truss assemblies and function to prevent a step that is sagging by

more than _____ inch.

Answer:

step level, 1/8

Q: Per code, an installed escalator can exceed the 30 degree angle of inclination by _____

degree.

Answer:

1

Q: When it comes to moving walks code states that the angle of inclination of the truss from the

horizontal shall not exceed _____ degrees within _____ ft of the entrance or exits and shall not

exceed _____ degrees at any point.

Answer:

3, 3, 12